A world of caution about Bat’s Blood Ink:
Bat’s Blood Ink is a very powerful and very dangerous tool. My first advice to all novices is: Never use it!
It is true that this ink is more well known for its malevolent uses and even then, a slight lack of concentration during the procedure can curse the user a hundred times more powerfully than the intended victim. Not to mention that even if everything goes “right” a curse is sure to backfire as black magic always destroys the caster. If you want a powerful ink that is much safer to use, try Dragon’s Blood Ink.
The beneficial uses of Bat’s Blood Ink:
If you insist on using Bat’s Blood Ink, make only a small amount of it and make sure you’ll properly label the bottle. You don’t want to accidentally use this ink for any other reason. Of course, here I’m going to give you only beneficial uses of the ink, and these are:
* Removing obstacles (caused by black magic, hexes, or any other reason) and thus, turning bad luck to good.
* Undoing the power of negative spirits over you.
How to make Bat’s Blood Ink:
So, what do you need to make Bat’s Blood Ink?
- 2gr Dragon’s Blood resin
- 1gr Myrrh resin
- 1gr Gum Arabic
- 12ml Alcohol
- ½ cup water
- Dark red colouring – optional, to make the ink darker and better for writing.
Ground the resins and the gum to a fine powder. Then, boil about half a cup of water. Lower the fire and pure the gum Arabic in the water. Stir until the gum is fully diluted. Then put in the rest of the resins and keep string until you have a honey-like paste. Then take the mix out of fire, let it cool down to approximately 60oC (140oF) and add the alcohol. If you are using colouring, add it now. Stir until it becomes an homogeneous liquid. This is your Bat’s Blood Ink.
Depending on how finely you have grounded the ingredients and how much water had remained in the paste, you may need a little more or less alcohol to end up with a proper liquid. But whatever the case, the ink will work.
How to use Bat’s Blood Ink to remove problems and obstacles:
Light a fire in your cauldron and infuse it with purifying power. To do so, chant “Hum” or “Ksham” 108 times over the fire. Of course, always take all fire safety measures when using fire.
Add to your Bat’s Blood Ink a few drops of a Banishing or Uncrossing magical oil. Do not substitute with a Road Opener, Block Buster, or Success Oil. With this oil empowered ink, write on pieces of paper your problems and obstacles. Do not, under no circumstances, write people’s names. Only situations.
Then throw the papers into the purifying fire and let them burn to ashes. Even better, summon a fire Deity or a fire Spirit you trust to assist you in this procedure.
How to undo Evil Spirit’s power over you:
Add a few drops of a Banishing or Exorcising magical oil in the ink. With this ink write the following square on a square piece of rice paper.
On top of this square write your name with Dragon’s Blood Ink. Under this square write with Bat’s Blood Ink the spirits or kind of spirits that cause you troubles.
Roll the piece of rice paper to a cylinder and tie the cylinder with seven threads of seven different colours. Do not use golden or silver threads. For best results, use threads of equal size as your hight and tie only one knot with each thread. That means, the cylinder will be held with 7 knots. Alternately you can tie 11 knots with each thread having a total of 77 knots.
Anoint the tied-up cylinder with a Banishing or Exorcising oil – preferably the same you’ve used for the ink. Then wrap the cylinder in a piece of plain paper, and once again anoint it with the oil. Keep the talisman in a safe place and regularly anoint it with the oil.
Once again, remember, you write your name with Dragon’s Blood Ink, not with Bat’s Blood Ink. Also, don’t write names of other people in place of spirits. Not only this talisman won’t work, but also you’ll be cursed.
Always be fully concentrated to whatever you are doing while using Bat’s Blood Ink.
That’s it. Have fun, be careful and be safe!
